-
ok guys today I have read the original file of my e60 in about 2 minutes with mpps sticking a charger on the car ? very fast, it remains to be seen if he can write with equal ease
-
it works really well, I think the e60 the write quietly but collegaci a nice charger, otherwise it is a drop in the voltage below 14 volts.
-
I connect the charger and while reading I marked 13.5 volts on mpps ? little? the battery ? new
-
THE AVERAGE USER
To be safe, the voltage should be at least 14v, cos? it's less risky.
-
and how do I bring it to 14v?
-
THE AVERAGE USER
Depends on the charger... if you have different methods of charging should overcome the 14v.
-
Or it takes quite a charger or use a feeder, adjustable up to 15 volts, and set it to 14.3. In programming it after about a minute, the voltage tends to drop below 14 volts so be careful.
-
I have a charger of bosh, but exceeded 13.5 volts to charge you disable the automatic power supply do you have any advice precise on where to find it?
-
THE AVERAGE USER
put power supplies are adequate a few times, leave the fans and the voltage drops quite a bit, with the necessary precautions this serial though ? a clone does not block anything
-
do you have any advice about it? where can you? find a good power supply?
Write permission
- You you can not post new threads
- You you can not send answers
- You you can not send attachments
- You you can not edit your posts
-
The rules of the Forum