Mpps V.12 higher than the V.5 ?

[simone82]

in fact, I preferred that,there are lots of 1000 for a clone for? are more? quiet

[garret]

I expect there to be something valid qu? on the forum, perhaps in a section devoted to the sale of programs however, the opinion of experts like you ? always valuable and useful to all, I am comparing are in the first grade azzz

[simone82]

expert now not to overdo it too, I am a novice to? I want to put myself seriously

[garret]

I am also fascinated by this world, but I think it takes time and passion to learn, then ? my job I do anything and I am careful not to compete or create problems to whom ? in the industry and working with passion and professionalism, ? just for personal knowledge

[polini]

mpps v12 ? true that makes a few cars in the pi? but it is very difficult in the can, and the protocols do not work well...

[saivivere]

I am up to date with mpps v12, I have never had any problems. Yesterday I loaded a map on a bmw serie1 120d 163 hp and ? everything went well, done in writing (with slow recovery) and a power supply connected to the 14 v, written in about 2 minutes.
The next tool that acquister? ? surely the rooster v2 that they say go well.

[dvdtuning]

If the power supply fails ? stable 14 v, 14.5 v and rises and falls of 0.4 v and never fall below 14 v, it could cause a blockage?

[garret]

I am up to date with mpps v12, I have never had any problems. Yesterday I loaded a map on a bmw serie1 120d 163 hp and ? everything went well, done in writing (with slow recovery) and a power supply connected to the 14 v, written in about 2 minutes.
The next tool that acquister? ? surely the rooster v2 that they say go well.

your ? original or clone?

[saivivere]

My ? a clone. As regards the power supply I connected in parallel to the battery, a power supply providing 40 amps of Diamond that I use on two-way radios, with power stable at 14.3 volts, as soon as I started to write, I turn on the various lights on the instrument panel and operates the blower of the fuel tank. I am afraid, only at the end when as soon as it finished writing to the flash and checked the cks I will close the prog, it never happened in normal writing. I had a terrible fear, but after turned off and then on the picture then everything is ok. I also redid the read the ecu to verify that the write was successful and ? was ok.

[garret]

very good a very good clone then