Hi to all yesterday trying to make the reading of a golf 6, 2009 with the kess 2.47 v2 I found the error in the reading of the ID by showing me only the version of the software but not the hardware to identify the control unit the error it released me this message:
Caution the ecu is not identified
For a correct procedure to send the log and read the file to technical support. Continue anyway?
with clones sometimes happen, in any case, if you gave the number to the sw means that he has spoken with the ecu, you should know that the ecu you have on the machine, however, if the protocol is right, even if it gives you that message you the reads and writes anyway.
P.S. ARE YOU SURE OF THE DATA THAT YOU WROTE ABOVE? A 2000 WITH 110 BHP ON THE GOLF COURSE 6 I DO NOT REMEMBER IT.
ugo ---- president A.E.P.
Sisi porya 81 kw booklet and 110 hp
ok it should mount a edc17cp14 or a edc17c46, and in both cases I advise you to get over the counter in boot-mode.
ugo ---- president A.E.P.
in fact, should be protocol 198, in every way a better bench and go to the safe.....
Thanks for the clarification even though I have never written anything until now, not even in the obd, then I'm taking the information to understand before something a little so I need to look for some help around here I can't receive file are not enabled
read with ktag
Write permission
Quote
