As the title suggests, I have this problem with this tool, the first time on the Fiat sedici edc 16 c 39, is the second time the same problem wrong code on edc 16c39 alfa 159, file read just fine, wrote it after the mod with gallo 48 everything is ok thanks do you know if it is possible to solve the problem thanks
In the net I found this solution someone of you has tried that already, thanks.
In the menu on their computers, there is an entry "setup" allows you to choose the speed them you have to put "minimum" if it still doesn't always go in setup, go to the item pull-up and parties by selecting the lowest value until it goes
you can try lowering the speed, on some ecu work, on these but there have never been any problems, maybe your could have problems with hw, with the components farlocchi to replace.
also, remember to update all of the libraries, visual c+ on your pc.
ugo ---- president A.E.P.
As a library, I have all,as a tool it seems pretty good, the only question that a colleague has given me another software for the installation and not the one that came with the tool anyway, thank you for your assistance good workOriginally Written by ugoboss
excuse glittering chiffon party dress.fitted...which version of sw you have?....it seems to me that with that fw you can't afford the latest version.
tomorrow if I have time, I look on my version...is a bit dated but until now has not missed a shot.
sometimes it happens when the car is not in the ecu file ori and kess was not able to verify the cks before writing goes in the block.
As sw I don't know, I have all the protocols enabled as FW 5.017, thanks
I found the order sw 2.23
the sw 2.23 goes well, the limit also works with the 2.47, test with another edc16c39 fiat if you get the same error, but I repeat, these do not have problems with if, and to the place with the hw.
ugo ---- president A.E.P.
On 2 occasions I had the problem, fiat 16, and alfa romeo 159, the only question that comes to me is that I have not installed the software on the tool, connecting reliable provided me with another that's more simple to install and not install , I only updated the libraries that you copied to your c: drive the program, installed the drivers and it all worked out I will follow' your advice is still the edc 16 c 39 occur, and it is now a tool to the end of his career, thanks to all and good work
Quote
