Doubt number hw/sw MJD8f2

[puntospeed1.3]

Hello all, after a bit of inactivity on the forum I find I have to do with a G. punto evo 95cv of my brother.
I have galletto v53.
The thing that does not add up is that the label of the control unit shows the following numbers. photo-->

While opening with multiecuscan, the numbers change. photo-->

some time ago I tried to do the virtual read, but the file was not in the database of the rooster.
these I know that is only in writing. I read just the injectors.

or there has been an upgrade in fiat, I don't know, by 1 programming in diagnosis. to 52.000. now it's got 120,000

[puntospeed1.3]

Sorry I've seen around that it is actually an update. and I also found the file. with which I agree.

It would be the 1st of 8f2 which I write, a few tricks? should be can, how do I know?

thanks.

[Errecinque]

Sorry I've seen around that it is actually an update. and I also found the file. with which I agree.

It would be the 1st of 8f2 which I write, a few tricks? should be can, how do I know?

thanks.

Yes the Gp is in the can, but I don't know if it is with v53 can't make it, you may seen that your brother try to open it, and read it to the tour so you have a bk full

[ugoboss]

with the v53 I've written several with no problem.

[falchetto8819]

hello, I can confirm with a little delay, however, you can do it safely with the v53 2 years ago I did mine, was in your same condition with upgrade done by fiat.

[puntospeed1.3]

Sorry I've seen around that it is actually an update. and I also found the file. with which I agree.

It would be the 1st of 8f2 which I write, a few tricks? should be can, how do I know?

thanks.

Sorry if dusted qst discussion.
There a way to verify that the file that I have is correct? And' saved renamed with the right number. But in any editing program load information. Like all the rest of the file 8df 2 mega.

[cinqueturbo]

Sorry if dusted qst discussion.
There a way to verify that the file that I have is correct? And' saved renamed with the right number. But in any editing program load information. Like all the rest of the file 8df 2 mega.

With any program in Hex you can see the HW & SW

[puntospeed1.3]

With any program in Hex you can see the HW & SW

Thanks. I hadn't thought about and tinkered without find. I see, try again.

[cinqueturbo]

Baaa simple..
you have a 8DF? search 8DF
you have a NEVERTHELESS? looking NEVERTHELESS
do you have a Bosch? search for 028 or 103
do you know HW? search for HW
do you know SW? looking SW
you are aware of any code to spare? looking for code replacement
and this on 99% of the ECU.. also Siemens, Sagem Marelli Bosch Delphy Delco, Valeo Visteone FoMoCo, etc, etc,
and there are 100 other ways to get there..