pairs of sertaggio 147 1.9 jtd

[MustangGT]

Hello all cone from the title I need to know the torque of the mia147 1.9 jtd of the pulley of the camshaft.
The removed in order to replace the water pump.
I have the tightening torques of all of the distribution except that this pulley.
Thanks in advance.

[saetta]

Hello 120 NM

[MustangGT]

Hello thanks fact.
Set in motion an hour ago, the game with half a turn of the key.

[saetta]

Ok usually the Jdt always start at the first shot.

[MustangGT]

be for the clio and it was so.....if you do not touch the injection or the other as you switched off it should start if you have not done cosini with the phase.

with the dime, and practically impossible, but who can put a motor out of phase with those.

this version (1.9 JTD 116CV) does not need to be set in phase of the fuel pump, but for safety I have marked the points on the pump.


already made 500km in just a few days, still has not broken anything then I think I did everything correctly .

No offense to the many of you who definitely are dedicated and honest.

But here, the machines spend more time at the mechanic than with owners, the was from 3 different mechanical, 4 +4+ 3.....11 months to get, then, exactly as the flow rate.

I stacato and I decided a little at a time to fix my car.

So if you stop in the middle of the road because the mechanic says he has done the work and then at his own expense the you have to bring back the relief he certainly will not take responsibility.

at the end for being so risk and if it goes bad something patience!......

Every time you go to the barrel of 2-300 € to have the same flaws, the same losses, and to get it to the 110, you had to find a good descent!.