immoff on marelli 5am hw103 and 610

[albertoS4]

the power is not getting to the coils because the immo is ON... then you should try to load the file s2r1000 that I posted a few posts ago with the immo off directly on to the unit iaw5am Hw610.
I do not understand why your friend may have tried to open the ecu to read it.....these ecu's are resin and not that open, the boot mode is active via SW

[Dirdan]

The problem was there with his ecu, from which I read the files from the 320 and the ecu was no code Immo. The starter turns over but the coil does not reach current.
The attempt to open the ecu, the receiver had the intention of scodificarla and make it virgin as the one mounted on the bike, the galletto v54 need to put a pin to ground to put it in the boot, and then the decoder.

Now should I get a new ecu and try it.