EDC16C39 - cloning

[alfona156]

I would like to upgrade my tools and I ask you
advice on which hardware to read the ECU by OBD....
I'm sick of open almost always!!!!

[saetta]

hello sorry for the silly question, to clone a unit, in addition to having the sw and hw the same it is necessary to dismantle the lid of the ecu?
for the cloning of the units must be always strictly the same? or you can venture to install another ecu?

[tranky]

hello sorry for the silly question, to clone a unit, in addition to having the sw and hw the same it is necessary to dismantle the lid of the ecu?
for the cloning of the units must be always strictly the same? or you can venture to install another ecu?

For the compatibility see esitronic, maybe she has other hw compatible.. More easy for software but nsé some never sapé...
What does the cover? Has the slopes and the members of the cover?

[saetta]

no wondered if it was necessary to remove the cover to put the jig on the board of the ecu?or do only links to the pins of the external control unit.

[ugoboss]

no wondered if it was necessary to remove the cover to put the jig on the board of the ecu?or do only links to the pins of the external control unit.

depends on the type of ecu, and by the equipment you use.

[salvatoreragonese]

Then that change is sw there is no ne frega nnt

[ugoboss]

so guys, here are two things or I do not understand most anything in my (and can be given the age) or the Italian language was changed, salvatoreragonese above says "if I have to CLONARLE two control units," THE TERM CLONE SAYS THAT YOU DO THE SAME and in that case you have to put in the full backup of flash and e2prom, certain that if then you put it in the wrong car does not start because of the key codes, but I followed his question, if you instead want to just switch the flash changed that is not a clone of the ecu, and in that case the council not to pass the flash completes, but write the changes on the second flsh ori.

[salvatoreragonese]

so guys, here are two things or I do not understand most anything in my (and can be given the age) or the Italian language was changed, salvatoreragonese above says "if I have to CLONARLE two control units," THE TERM CLONE SAYS THAT YOU DO THE SAME and in that case you have to put in the full backup of flash and e2prom, certain that if then you put it in the wrong car does not start because of the key codes, but I followed his question, if you instead want to just switch the flash changed that is not a clone of the ecu, and in that case the council not to pass the flash completes, but write the changes on the second flsh ori.

Hello Ugo. However, I intended to take a unit to collapse and put the full backup of what I have , not only The flash but also the micro and e2p perhaps. Perhaps we are ill-understood when I said that the original was mod.
However, we understood each other from the. Good day to all guys

[lsdlsd88]

Thanks a lot for the clarification.
The part that had left me perplexed, her question was this:

if I have two controllers and I have to clonarle because a already mod and the other is not

As if he wanted to use a backup of an ecu already mapped on another drive.
Maybe I misunderstood I?

[saetta]

Hello me explain the difference between flash micro ep2? Thanks