Solder pin spring on schedule

[fabioefra44]

Guys I have to solder the pin to the spring on the schedule of the bdm, those bosch no problem, but for those of siemens and marelli, which has very close... what equipment we want to? you just need a welder and hand firm?

Enter the e xxx on the jig and get a quadrello of polystyrene, and you will see that remain still

[rgiubert]

you can do this even without solder using a small vise and trying to maintain the perpendicular to the e xxx. You can build with panels already? drilled and tips with the spring there are various measures and steps in the shops of electronic components or, preferably, in the fairs of electronics.

[msport (exil77grande)]

you can do this even without solder using a small vise and trying to maintain the perpendicular to the e xxx. You can build with panels already? drilled and tips with the spring there are various measures and steps in the shops of electronic components or, preferably, in the fairs of electronics.

I'm sorry, but have you seen the presentation section?
I invite you to introduce yourself and read the rules, thanks.

[rgiubert]

I ask sorry. I shouldn't have.

[sportknight]

solder the siemens ? a suicide

[maku1977]

other solutions?

[alex68]

other solutions?

these mentioned by the other colleagues are excellent solutions.

[nicospl]

the sheet of polystyrene to keep it stationary ? a good idea

[maku1977]

mostly I meant to keep it in the "template" the needles....

[cawadany]

I used the supplied adapters to the rooster, and I would say that the result is very satisfactory.

IMG_20160714_154958.jpg

IMG_20160714_155004.jpg

IMG_20160714_155011.jpg

IMG_20160714_155032.jpg