edc17 cp14 to clone or scodificare

[sportknight]

Hi guys,I have a edc17cp14 to clone or scodificare
what can be done? I know that they are a bit steep
I have the backup of both of course

[sportknight]

oh well,I will update

I cloned the ecu that at the end I found to be different in the software but the same in the hardware,it's a passat
the car however was not so I had to scodificare totally and the drive part, and it's good

of course, you turn on the light of the immo and the one of the glow plugs

[dangy]

considering that this is a very fair response

[giulianoA3]

hello, at the end with the lights how you fixed it?thanks.

[giulianoA3]

hello, is there any news on the cloning of this model of the units?thanks.

[ugoboss]

on these the ecu to have a bit of security in the success of the work of cloning , you have to start from hw and sw the same, in that case you may have a good chance, otherwise I see hard cloning, it is better to go to scodifica and then see it with the lights on how to resolve.

[giulianoA3]

in fact, I have 2 ecu's the same in hw and sw.

[ugoboss]

in this case we advise you to have a backup of both of the ecu , against the file, and then transfer the backup to the 99% should go, but the last word from the machine.

[giulianoA3]

is this you called is the only test that I could do it cunsiglio of a friend..but nothing to do!!there is no state to.

[munro]

the main problem with the eoc-med17 are the "rsa" and the rollin ' code, even between the 2 ecus are exactly the same hw and sw and easy that the above is different..
It would be to try to see where exactly are located the "keys" that the rollin ' code, and at that point manually intervene to exchange them from ecu to ecu,at least in theory..