Mjd8f2 file 2049kb or 2048 kb

[cinqueturbo]

Ok thanks, saw that the mystery thickens (2 days of news discrepant around the web) , I'll try to open it and let it in jtag and I do bk. Sorry to bother you, just tell me which file goes moddato and rewritten always in the jtag with no surprises. And if you already have then tried to rewrite it to serial if you can rewrite the same file that is read in jtag without cuts and belinate various. Thanks

No you can not write to the file j-tag in serial, you have to cut that 1Kb from the end of the file, and then write
You do reason the first one made too, in the j-tag..
but since that tool apple allows and I have no problems to take them again even if it goes wrong "never happened" and open and close them again this ECU is not a walk I always do in the serial..

[Errecinque]

I also write here saw the post opened by me.

Regarding the marelli mjd8 confirm (I just tried I on a file) that if we have a backup in j-tag from 2049kb cut it with the ecm to the address 1FFFFF, and we will have a file to 2048kb ready to write serial

[ugoboss]

hello, errecinque you can put a photo of the ecu, thanks.

[Errecinque]

hello, errecinque you can put a photo of the ecu, thanks.

Hi ugo I have the car in hand you will now place the data.
Hw MJ8DFHW00A
SW 9754B187
VER.SW 0087
SPARE 51896812
VER HW 00

[Errecinque]

Those with kess...and cock giving me
51896812
MJ8DFHW00A
9754B187
8F2.B1H.
0B B1 0719
.8F2.B1...

[ugoboss]

the sw is different from what I have read on the serial line I, the mine was 9754B287, in any case, I don't understand why you can't read it in the serial.

[Errecinque]

the sw is different from what I have read on the serial line I, the mine was 9754B287, in any case, I don't understand why you can't read it in the serial.

Watch...in a week we tried again because it is already mapped and I wanted to pull out the file that is there currently and then the cock is not for my case. I understand that I will have to do a reading in approximately 2 hours...if my kess connects (they have also advised me to change the speed and set it to the minimum) . I know.thanks

[ugoboss]

then the hole in the k-line and you will see that it connects, reads the injectors (not as you say that it reads them only in the can) and then re-enter always (k) to read it takes a while, I don't remember how much, but more than an hour, it is very first, put in a battery to support the machine and the laptop attached to the power supply, and you'll see that everything goes right.