Hi guys,

I just took possession of a Toyota Yaris 1.0 (Engine is 1kr-FE),
this machine is equipped with a Bosch ME 7.9.52, however, before starting a
in the processing I need some advice.
Therefore, I will use the Ktag Clone the most recent version.
On the guide to be able to read this ECU says to do 2 welds with wire,
1 to the PIN of the Boot and 1 for the PIN CFN1 and only with this it is possible to read and write
the ECU.
However, since I'm not sure I've tried the other; on other sites they say to put 2 resistors of 1Kohm each
others, however, put the other wiring in the ecu as in the picture:



Can someone help me?

Thanks to all of you!