ebc16 c8 alfa 156 jtd16v locked after writing kess v2 clone

[GRAZY]

hello everyone I am new in the forum I January a kess v2 clone with tokens to be reset with j-link after 38/40 reads/writes.in January, I reset already 5 times more or less 200 scriptures, and I never had a problem, yesterday I tried another map writing finished as usual but the machine will not run! turning the keys, I noticed that the fuel pump in the tank does not turn and does not turn on the light the engine, but stays on the light of the CODE.I tried to replace the original file, but nothing, not even ID or tried the recovery but nothing to do I also tried multiecuscan to see if it gave some msg in the CODE but does not recognize the ECU would give me a hand thanks

[leo_sg]

you should resume the tour probably

[andrew64]

Test many times in the recovery 30/50 times if it fails go to bdm

[sportknight]

the unca solution is the bdm,also try to disconnect the battery for a bit and then a rewrite

[todos]

Hello, you can write in bdm, but you should have the file read in bdm, and not the obd....

[blackwolf76]

Read it through Bdm and then try to rebuild with the original.

[NinoEcu]

Send me the Data the ecu SW and HW That You step I file in bdm ok

[GRAZY]

hello guys thank you all for the answers!I tried again tonight, the battery was disconnected since yesterday but nothing.tomorrow I try with the recovery insisted, and if that does not work I try in BDM,the fact that the car was already mapped, then the original don't I'm not even in the obd, however, SW986 HW332 thanks

[NinoEcu]

you have to be more precise hw and sw ecu model
the file you step I

[NinoEcu]

disconnect the battery serves no purpose
and a ******* when you write a eeprom that you disconnect the battery you reset I don't know who said it but it must not be so