Hi all , I wanted to ask if you can write on a sid 804 a file ori with the same hw, while the SW is slightly different , the car in question is a fusion 1.4 tdci 2005 68cv.
I think that you should first compare the 2d and the 2 numbers sw different and see if all the areas are perfectly aligned. The maps, the engine management may also differ in the values but the rest should match.
I think that you should first compare the 2d and the 2 numbers sw different and see if all the areas are perfectly aligned. The maps, the engine management may also differ in the values but the rest should match.
The car was taken to the workshop with engine failure, and does not exceed 2000 rpm and did enter and exit from the other workshops, worsening still more the situation, and because the customer is tired of this situation I brought the car to verify it of course does not know what has been done , the diagnosis presents only an error " sensor, vehicle speed" one of the first things I did was download the map and test it with an ECM that does not recognize as a gold then I compared it with a map of a fiesta with the same hw and different SW and there are increases in strange out of the drivers and many of the bits set to zero as if you have tried to eliminate some of the dtc and I have created a bit of a mess.
Quote
