Fiat 500 1.3 nevertheless, 08

[ciccio84]

hi friends this car and my property nevertheless, 1.3 engine code 169 To 1000, and use it in company as courtesy car!
Yesterday I started the car cold and I turned on the light engine, however, was good,in the evening, the wizard, my brother, and found that the car is not gaining speed.
This morning I made a diagnosis and I have come out of these 2 errors p2135 p0704,the one on the clutch is an error that carries with it a life, but that of the accelerator pedal is never released.I cleared the errors and did a test drive and indeed the car in times good rooms of laps and sometimes not, and after a few miles we turned back on the light engine failure.

[carlo abarth]

and what gives you after the reset error???

[ciccio84]

Always gives me the error p2135 and the car does not accelerate more than 3000 rpm.I checked in the parameters and the position of the accelerator pedal rises to 100%,then there are also 2 other parameters pedal position 1 ad/c and 2/,li, however, the measurement in volts, and the minimum 1ad/c marks 0,7495 and 2ad/c 1,0124.

[ugoboss]

make sure to check the connections on the pedal, wipe them and test, if it comes back to make the error change the pedal, I have already come to similar problems.

[leo_sg]

This to me, just last week, in the diagnosis, it worked fine, but then disassembled and tested with the tester actually gave some small difference in the resistance, the changed, and until now everything is ok

[ciccio84]

You changed you own the pedal?As soon as I have time, I would like to see the connections, because from yesterday evening to now the car is going well,but I have not done nothing, only a reset with a diagnosis.

[leo_sg]

You changed you own the pedal?As soon as I have time, I would like to see the connections, because from yesterday evening to now the car is going well,but I have not done nothing, only a reset with a diagnosis.

It is in the pedal is the potentiometer

[ciccio84]

You, however, it seems more a problem of connection because now it has started doing it sporadically..

[DavideO]

To me, it is happened that you changed the pedal and it was resolved..to the limit, you can first try to fold the wire on the connector and put a clamp, as it is under the seat for the lamp drivers so to speak..if it is caused by a lack of connection to the vibration should not do it

[Fabiodegliangeli]

Change the accelerator pedal and add the clutch switch