Help the map

[mistergame]

if you are up to it give me a small aiutini to begin to compare the two files. Then I have my ori (finally), and I have the mod file. You (msport) you told me that on the ecm 2001 there is a driver that is very close to my and the 449. Then starting from the beginning, I have to load the driver first and then the two files (ori and mod). At that point I go on the 2d, and I should veedere the differences between the two graphs overlap. Up to here we doremmo be.

[msport (exil77grande)]

if you are up to it give me a small aiutini to begin to compare the two files. Then I have my ori (finally), and I have the mod file. You (msport) you told me that on the ecm 2001 there is a driver that is very close to my and the 449. Then starting from the beginning, I have to load the driver first and then the two files (ori and mod). At that point I go on the 2d, and I should veedere the differences between the two graphs overlap. Up to here we doremmo be.

yeah,but you have found your file ori or are you using one of our data bank?

[mistergame]

but on ecm2001 you must upload it to force the driver to then compare the two files?

[mistergame]

ok the files and drivers that are loaded. Now I go on the 2d, and I see the chart. The question is this. The addresses of the various sections where to find them? I have read in this post some addresses that you gave but are not clear to me.

[msport (exil77grande)]

ok the files and drivers that are loaded. Now I go on the 2d, and I see the chart. The question is this. The addresses of the various sections where to find them? I have read in this post some addresses that you gave but are not clear to me.

if you look in the part of the winged central find sctitto address-dec-esa virtually scrolling through the file, you must reggiungere the various addresses that I have written but still in the initial page of the sw are already in the maps drop-down as the turbo,injection, etc.

[mistergame]

finally found

[msport (exil77grande)]

finally found

could you post the file ori?

[mistergame]

here is my file ori

[msport (exil77grande)]

here is my file ori

this file is the same in all the files ori from me posted,then or did you wrong by posting my ori or your mapper was not your own, and sent you an ori compatible generic.

[mistergame]

ok I have uploaded both my golds that my mdo with the driver 449. I went under pressure turbo and I open the 2d. I have a chart base and height. Height varies from 0 to 4100 and I think that's the nuer of revolutions of the engine. The base must be from 0 to 255, and I don't know what it is. In blue the file gold and red the mod file. Who can help me to interpret it? Scorrendolo tells me that these curves were increased by 4%. That means that the pressure of the turbine was increased by 4%? And' an increase in fixed 4%?