golf plus 1.9tdi 105hp review, egr

[msport (exil77grande)]

guys what about the last post. and the choir so tomorrow the load

for me, so okay,in the case as a matter of fairness if you have to do to diagnose and test the egr control ori then do mod it so, and, finally, if you like you can do a third test to see if there is a difference.

[ago27]

no you do not have to start from 0D5344 to 0D5360, but you have to select exactly the two addresses indicated by msport, it is clear, then when you go to make sure you'll see it from 0D5344 but it is not from them that you need to change, absolutely no......

[msport (exil77grande)]

However, I think you were wrong to indicate the addresses. By selecting the +/- the maps are brought to the centre, and if we want to reset the second one as the first one I need to bring to zero by 0D5344 to 0D5360. Or am I wrong?

Annex 1482

I confirm what was previously written, for me the addresses you want to select are from 0D5346 to 0D535E because as you have selected you there are some maps where the controls are slightly different and would be unpacked,you will always select from the top never from the bottom point,guys without presumption I these controls do them with your eyes closed and think so if anyone has different ways and is right on the cg?he will do as he sees fit.

[ago27]

thanks msport, finally I managed to do that then was not very difficult, I feel I have a cable vcds 10.6 and that you know the steps to see if the EGR and closed. Thanks

[msport (exil77grande)]

thanks msport, finally I managed to do that then was not very difficult, I feel I have a cable vcds 10.6 and that you know the steps to see if the EGR and closed. Thanks

we are here for,no I'm sorry for this I can not help you open a post in the suitable section of surely someone unfamiliar with this cable you can find it.

[ago27]

but just to know the first control as you adjust it ????? No because I have modified by hand, the cio? I selected the two addresses, and then less, until and down to -100,0, or there is a method more simple to do it as the second control, i.e. by pressing m.....thanks

[msport (exil77grande)]

but just to know the first control as you adjust it ????? No because I have modified by hand, the cio? I selected the two addresses, and then less, until and down to -100,0, or there is a method more simple to do it as the second control, i.e. by pressing m.....thanks

certain you need to do exactly the same thing i.e. to select the beginning and the end of the 2 top corners, and then select m lowercase of course, the map must be in the bass if you have +/- selected or not, and it's done.

[cawadany]

I confirm what was previously written, for me the addresses you want to select are from 0D5346 to 0D535E because as you have selected you there are some maps where the controls are slightly different and would be unpacked,you will always select from the top never from the bottom point,guys without presumption I these controls do them with your eyes closed and think so if anyone has different ways and is right on the cg?he will do as he sees fit.

You are right, I am confused.....

[cawadany]

but just to know the first control as you adjust it ????? No because I have modified by hand, the cio? I selected the two addresses, and then less, until and down to -100,0, or there is a method more simple to do it as the second control, i.e. by pressing m.....thanks

Am I wrong or the first control does not ? perfectly to zero?

[ago27]

sorry but I can not find on our forum section dedicated to the cable vcds, someone can help me????