Hi guys after reading the discussion about the limiter rail pressure present on the 1.3 mjt 70 horses at 1460 bar I was intrigued and I wanted to try to make a "map" that has precisely this limit raised...I want to clarify that in addition to being my first map (it will certainly be in the section jokes heheh) have not made a calculator in hand for several reasons,the first is that I don't know enough yet,I could not understand, for example, how much you actually "a point" or more of change in the various maps, and that mainly, I was interested in testing this limiter at 1460 bar...I will explain what "I believe" have done and what I didn't really understand...first, the file is a marelli NEVERTHELESS 6JF.The P3 HW01B and SW 1064-P348, which I did in order : immo off with time,the exclusion egr manually, I have raised the limiter rail pressure that is located at the address 06748E bringing it by its decimal value is 775 (which according to the conversion formula is 775 x 2 = 1550 - 100 = 1450 bar) to 850 (which should be 1600 bar),I then modified the various available maps in the ecm. I have given increases to the rail of a maximum of 100 points, which I understand correspond to 100 bar (correct me if I'm wrong), I increased the map called "torque limiter 2" with maximum values of 150 point (I didn't get but really this is what it means), while for the "torque limiter 3" I gave 200 points (also here I don't know what it equals...).
I wrote the file on the ecu to "test" and realize the differences with the changes you made, but I have not had at least until now, no car available for the test. I attach now the file ori and the one I product.backup mjt muletto_Mic.rarMICRO_test1.rar