Problem Audi A4 ecu engine

[egs]

However both are EDC 16U31, then you can do the transformation.

[ducati83]

Guys I take the best spot to give you a bit of info: I tried to clone a ecu edc16u31, and nothing to do the car is in motion but has problems of failures of various....the case of the ecu with different hardware...it's to be expected...
I have proceeded with the replacement flash and it went well for some time now again the same problem,in fact I risostituito the flash and it's fine again....but secosndo you from thing can depend on the fact that the failure of the flash?

[obd75]

according to my experience you have been unlucky with the second flasks, except if it was recovered by ecu set aside for a defect attributable to the flasks.
these memories jumping for structural reasons them,not in consequence of anomalies of the circuit with which they are working(it is not the ecu that ruin the flasks).
so if the flasks you used now is safe, ok you are affixed..........

[ducati83]

no, I took this from the other ecu....it was new to pat....and it had not been simple....this leaves me puzzled...being new should not give rise to this phenomenon.....
well, I hope that it lasts as long as possible because the owner is a good client but very demanding.....he has many friends and relatives from me and I would not like to remain in walk while working....I already know who is the culprit....

[sportknight]

at least the hardware should be the same otherwise you have problems