simens sid 206 fiesta and mapping

[Errecinque]

The rolling code simply Immo, which changes automatically at every start-up..

Thanks ....I never knew him still under this name

[tekyla]

Then good evening to all let me see if I understand in-place file step 1 with the suggested changes ,my only doubt is in the limiters, I only increased the imitator map (17),the percentage of increase as they go?
regarding the procedure of the EGR before you pull out the connector then via the error code reads the map and passes on egr remove and reload?
right I've had a ....? I've never done it.
which one to use?on the v1.02 there are no sid 206

[clabsport]

if you want a board without incasinarti greatly increases the map rail and the limiter that is after,the injection times,the pressure to the turbo and remove the egr or removing the dtc and disconnecting the outlet(dtc remover free should do it) and already get good results

That I know of just makes the series 803 and 803A, when we speak of V1.02 or we have a higher version?

[tekyla]

good evening to all which to use for sid 206?

aiutooooo

[sportknight]

I don't remember, but studiandoti a 803 you can also understand how to make the 206

[tekyla]

Yes ok but how can I study it if I can download it?

Today I tried to read a leon cupra 4*4 with gallo v50, but it is possible that the ecm does not have the drivers?
I'll open up another thread with the file I hope you will participate.
A good dom at all.