read in bdm or serial

[cinqueturbo]

now, I can't try it because by this test has blown a transistor and a capacitor of the rooster so it all seems ok tonight, change them and then try to read an ecu that already has the bed to see if it works!
only I don't understand why it happened this unless it is successful for the problem to the power supply.
to read in the K-line I have to select the car on the software of the rooster, right?
in the boot I don't have the schema and I don't know if you can do that, and I know these ecus, or read the so or with a programmer by unplugging the flash

No actually, it is not feasible to read in the boot.. but a simple reading tour..

here is not to be used the adapter that I remember, and to verify at the moment..

[ugoboss]

I when I have to read these or other at the desk to use the cock as if I had read it up in the car by diagnostic socket, and then use the cable obd (with adapter) and with an adapter on the plug obd with which I take the k-line and food all from the outside with a feeder part, on this then you can have the problem code and you need to remove the e2prom.

[project]

I resolved I had made a mistake from the first grade right! I had reversed the polarity from external power supply, damn it! however, I repaired to the cock and rirovato to connect it with the pin out, everything went well! anyway thanks to all for the courtesy