recognize bosch ecus

[ugoboss]

ugo that and a small white!!!

hahahahahahahah I know, but to me it happened and then pain.

[ugoboss]

I understand...so now I have a new question,Are in possession of a unit new that mounts on the 156 1.9 jtd 105 horses and then the first in the series and, therefore, edc15 right? I opened it because I wanted to use it as a truck maybe scodificandola to be able to try on a car of a friend, and I noticed that it does not have the contacts to the bdm as that of the chroma which I mentioned earlier, but if I remember well, only 8 people,and then not having the under hand I'm not sure but I was wondering if the bdm I have to connect them and if so what is the wiring diagram.thank you all in advance

the edc15 does not have the port BDM, for the scodifica do it on the flash.

[giuseppe89]

I'm sorry if I insist but not knowing it very could you explain better? For flash do you mean on the chip? What do I need to do it talking about hardware and software? I would like to use the private ecu as a test but not having the car I would like to make no code

[Andrea1]

no experience with that type of ecu, but if I understand it, you're forced to rewrite the flash (I call it eeprom, but sometimes I confuse a little) of your edc15 with a programmer type upa or similar... look in your ecu for a chip with the code 5p08c3 or 95p08, more probably, I think you will find the second one but I go to the memory and then check for both codes

[Andrea1]

no experience with that type of ecu, but if I understand it, you're forced to rewrite the flash (I call it eeprom, but sometimes I confuse a little) of your edc15 with a programmer type upa or similar... look in your ecu for a chip with the code 5p08c3 or 95p08, more probably, I think you will find the second one but I go to the memory and then check for both codes

I fix the initial error due to fatigue, sorry. I have no experience*
And may I add that your edc15 you must have read in boot mode and perhaps you might be able to scodificarla via boot mode but I'm not sure! when you read the ecu selects in addition to a readout of all the ecu a reading of only the eeprom, maybe you can scodificarla even so without to unsolder and resolder.

[giuseppe89]

Hi I have just checked on the galletto and boot mode does not give me any information of how to connect to the ecu...someone has a diagram and knows how to tell me how to proceed? Me boot instructions only for units petrol Fiat group and other that I can't remember... help!

[Andrea1]

to be able to help you to give me some more info... can you tell me that edc15 is? doing the search with the website that was given to us you should do it very well

[ugoboss]

if you want to read it in the tour, dissaldi the e2prom and then you can read scodificare and rewrite easily, and then use it.

[giuseppe89]

From the site Bosch tells me that it is a EDC 15C7-2.16 .nothing can be done without desoldering the Eprom?

[Andrea1]

BOSCH_EDC15_C2.jpg
in the file I have this and another one.. the known somilianze with your ecu? later when I get home cercerò better