just process the file, and when you weld the eeprom, the pin 7 and the lift from the PCB and put it on pin 8 of the same eeprom, and ? everything is ok
just process the file, and when you weld the eeprom, the pin 7 and the lift from the PCB and put it on pin 8 of the same eeprom, and ? everything is ok
are you sure that goOriginally Written by SIBERIA88
Try x to believe the fact on a palio by removing the box code before starting?... Let us know if it goes
Sorry Alfetta80 I've never done so many tests, why? ecu of the type c'? they are now few and I was never put to the study.
We just wanted to say as I did.
but if the changes to the e2p part without problems?or there may be problems?
aaaa ok, you need a partial, and the partial there are no problems, usually sw immo work, but also swap the e2prom ? a solution.
you can also make a tot. you have to cut the wire to pin 20 and I am not proven but the partial works very well tested 100%
Quote
