Mount Turbo Alfa 2.4 Jtdm 200Cv(Bw/kkk Bv 50)On the Punto 1.9 Jtd 86 Hp.

[munro]

I apologize DarioJtd and to all the participants of the discussion for the off topic but I have to moral obligation and respect towards our great munro
BUT WHAT YOU'VE DONE ?
I learned just now reading the various discussions that you have health problems, I'm sorry and I hope it is nothing major and the passenger..
From you and wish you a speedy recovery and to read good news in your excellent post..

thanks for everything guys and greetings to you, cinqueturbo...
the fact is that work has various commitments find time to post on the forum I was difficult but now I think I have more time to dedicate to this fine forum...

[cinqueturbo]

thanks to you I have also known the movies.. in addition to having learned more about chipTuning of course...

film-moto-burt-munro-affiche_hd.jpg

[frenk85]

where can I find the sensor?!?!a rail on a rail 2.4 would be fine?!?!thanks in advance!!!

[munro]

you can try to mount the sensor rail fiat 1.9 mjt 150 cv law safely up to 1800 bar only that you have to linearize the sensor in the map then you need the specifications of the sensor that go to mount...

[frenk85]

good morning to all! I was able to find and install the sensor reil,is a spear-lbs 2.4.I have made several maps, but nothing to do it remains implanted in the 1500 and does not move.if I exceed the threshold goes into recovery and power off.I have noticed only a very small increase of the amount of diesel the past 100 102.75

[munro]

lybra 2.4 with edc15 fitted with a sensor equal to that of the point....always sees max 1500bar...I told you that you need a sensor edc16 fiat 1,9-2,4 that reads up to 1800 bar then the same goes adapted in the ecu...

[frenk85]

I can't find a used sensor and the new cost a bang,I'm afraid then that I can not get it to work........
for the amount of diesel,it has a connection with these two things?!?!

[munro]

what you need to know frank?

[frenk85]

I'm confused!
the rail pressure,in my case,serves to maintain the right flow rate to the injectors, right?!?!I did some tests with the rail pressure and limiters ori 1350 and mod 1500 and I have not found any difference,****th e performance of the amount of diesel fuel.and the doubt has risen,I have 1500?!? why can't I get over 100 iq?!?! it will be just this sensor?!?!

[munro]

the increase in pressure if it does not bear an essential increase of diesel...
if you increases the press rail, for example, a 10% more you will not see 10% more diesel fuel is injected, but the more or less 1/4 of diesel in more than 2.5% in most...
remember that if you bring the pressure up to 1600 bar, and maybe you are limited in the ecu to 100mm3, the ecu will go in the map rail on a pressure lower than 1600 to give you the 100mm3....
all clear?