I should scodificare a Nissan Terrano having an ecu Bosch MSA 15.5-6, which is unfortunately still not possego a eprom reader.
I am a beginner and I am trying to slowly learn and equip myself.
For now I have only a wingnut v54 clone european.
S? of having to do the reading and modification of the eprom 24c02, but it's not? how can I do it.
And you can do this by using the wing nut?
No, you should need a programmatoret of memories is the most used ? the Willem find it easily on the internet
Ah ok, thanks a lot.Originally Written by gabrilupo
the Willem is clone ? Prices inclusive of all the adapters?
As you agirano prices inclusive of all the adapters?
Better Willem or upa?
I use willem 480 bought years ago.. now I saw it on ebay about 280€
Complete with adapters? A little thought we would.
no no only programmer adapters are not included and cost... then maybe you take them according to your needs adapters for the 24c02 etc should not cost you very much... I will recommend the tweezers to the 24c02
Ah c'? just the tweezers and I can read the eprom without disassemble?
in theory yes, but then it depends, I think from the circuit at times ? need to disaldare equally
Vabb? but having the tweezers you can? always try?
Or trying to read the eprom without desoldering, where not ? can be read without removal from the circuit, you are likely to damage? And also, with the eprom removed from the circuit ? anyway possible to read it with tweezers or at that point need the adapter?
Quote
