guys have you tried using the interface tricore read from the pinout?
guys have you tried using the interface tricore read from the pinout?
I've got it 5 days ago....ver 2.06 done writing with jlink but I get error MICRO ERROR ALARM clock......EDC17CP02.......I'm going crazy even with the cock v54 me by giving me error on boot
if even with the cock works, the ec has to take into account that it can be some other problem, have you checked if it uses the protocol and the connection diagram right, the ecu ? working, have you tried to replace it.Originally Written by meccano85
ugo ---- president A.E.P.
the ecu l I reassembled drive and it works. ....if I do with obd I ecu data with the cock. ....I bought a ktag hopefully I can with that......a few months ago I had the cock v53 with the dongle and I had made 2 of these ecu with the v54 I can't do it and even I have three of fgtech but all the same error boot.....instead of the kess reading around about the changes to do to make it work good part of the tricore......
the changes concerning the operation tricore, in the first version was a resistance, in the last version c'? else to change?
Hello guys I also started to have the same problems with another marelli in reading k-line with the kessv2 me too...gives me error alarm clock...I have noticed that from the wires in the output(measured with tester) that the 12 time does not come out but a friend told me that only read kess takes the 12 volts, however, always the same error, maybe I'm wrong, I something in the links post a picture...the k-line from theIMG_0622.jpg the site where I bought it says that the thread ? yellow
remove the module bootloader and read the help file for links.
ugo ---- president A.E.P.
the read thanks ugo time 5 minutes
but you have used the module tricore to read it?
I used the cable K4 with the line k-line read time 5 minutes
Write permission
Quote
