Delphi DCM3.7AP and Galletto 2 V53

[corrado]

I have made this pattern ....
but I have a doubt , the cable of which I have attached the picture you can see a white plug with wire for + and - , at the time of reading and writing on the instructions I have not found if it is fed to the power that v? on the fgtech .
can you tell me if this cable is powered or not ?
thanks !

[ugoboss]

that's the cable that feeds the comb of the control unit, and then we switch that makes you the place of the key.

[corrado]

that's the cable that feeds the comb of the control unit, and then we switch that makes you the place of the key.

Thanks ugoboss ,
then v? powered also that cable (over power the fgtech) for the j-tag ?

? for this that are not able to read it ?
(also why? the welds and the schema l' I performed well)

that's the cable that feeds the comb of the control unit, and then we switch that makes you the place of the key.

re-reading your response, perhaps I have not explained well, or ? been poorly understood the message where I asked for a clarification on the plug, white in color with two wires + and -.......

someone can? explain the use , thanks

[frantik3]

feed the ecu

[corrado]

feed the ecu

...... then ? a plug is 12v IN , and 12v OUT , I understand ?

[frantik3]

...... then ? a plug is 12v IN , and 12v OUT , I understand ?

You and 12Volt

[corrado]

You and 12Volt

yet reading in the guide that I have and both on that of the ori does not specify that ? an entry IN ? to be powered , the only one that is asked of food ? only the Fgtech .
so if it was or ? so the reason that has not done the reading ? for the simple fact that I have not powered the second White plug .
Yet the ecu I thought it was powered only by the wires, no?2 red and n?1 black , much ? true that I have also checked with the test the actual voltage , and having output 12v I thought that the ecu was already? powered..... I didn't think that this is a plug with two wires red and black was an entry IN 12v
I confirm that ? so ?

Ok , thanks all ....

I realized that seeing photos of other fgtech in my package was missing the red cable and the black with the white attack to feed the second cable ...

now repeat the welds with a due supply of both Fgtech and cable ... and let's see if this time I read the delphi dcm3.7ap .

Again, thank you all ;-)

[corrado]

anything you do not want to read this damn Delphi , do you have any advice besides throw it away and change it ?


thanks

[frantik3]

anything you do not want to read this damn Delphi , do you have any advice besides throw it away and change it ?


thanks

have you tried only one in the jtag?

[corrado]

you only jtag