but the xprog does not have the adapter for eprom zif 40-pin?
but the xprog does not have the adapter for eprom zif 40-pin?
ragazziiiiiiii,then? qualce programmer should I take?
the willem no, why? does not communicate with the usb port, but only through the parallel port
the xprog ? the one that has more? adapters and costs very little, but I have not seen the adapter zif 40-pin
then I saw the cinesone that costs very little,no one has it? ? the lag g540 with 2 or adapters plcc32 and plcc40
need those adapters? or are more? useful those who give with xprog?
according to the eprom, eeprom, micro, etc... that you have to eventually make purchases...
who do you serve 2 of programmers who each other are offset...
ok thanks
I have the upa that usually use for the drivers and I am fine for the engine control units never even used because I just started with the tuning of the ecu, however I advise you to see the car park you have then if you have money to throw away like others said buy 2 so you compensate
I also use I have g4 upa and xprog but go quiet g4 works well and has a price that is not an exaggeration.....
between the upa and the x-prog to begin what would you recommend for me?
xprog is a good thing.Originally Written by sportknight
Last edited by msport (exil77grande); 21-08-2013 at 15:28
I use a GQ-4X ... simple with fequenti updates..... and never misses a shot!
Azz, I'm confusing the issue even more ideas
Write permission
Quote