good evening to all
I ask for a little information: a file .hex of the map, how is it obtained? I would to run a a2l a edc16c34 but with sw different than the a2l that I own, and asks me a blessed offset during loading. Are the hours that we are around and moving but I can't seem to skip out.
Help me, please
test with offset 800000
with this offset doesn't take me even a mapOriginally Written by sergiot
if you need to place the map ori, and a2l
I add a zip with the a2l that I would like to use and the map for which I would
the bin file is correct and the maps are seen as shown in the a2l.
also hex seems right to you. but I will check later.
Ok, and how is it to me if I try to load: map 1.6 hdi 110cv my 2007, and to add l a2l certain maps, such as the driver's wish, I can't find it? I do not understand where mistake
at the beginning you say that the hex file is not what you expected for the a2l.
at this point, it is normal that some of the maps are, but it is a case, and other not the find.
the hex file that is there in the folder is just for the a2l that is always located inside the folder. my question is how to adapt the a2l to my files ori? there is the setting for the offset in load, since them we have, but how can I calculate? if I know that my ecu has sw xxx (a candidate hypothesis), while that of the a2l is yyy which method you use to make it compatible for my xxx? and then, there's a way to create a hex file from my files ori?
I spontaneously arises the doubt, seeing my map ori, the reading is correct at this point. Missing too much info in the initial part. I had perhaps read it in the boot or on the bench? I've read through the kess and kline.
Thanks a lot sergiot anyway for your answers
does not count for this discussion, the method or instrument used.
there is no way out.
the file a2l are compiled on the basis of the hex file to which they refer.
there is a method to change the a2l, to the extent of us operators in the aftermarket.
but a method to get there.
you open the right file with the a2l is right. find the maps you want, then you compare the different file looking for the same maps, that are there, but can be moved to address. often not very moved.
Quote
