iaw5amhw610 gp 800

[tekyla]

hello everyone and good Sunday.
From the outset that I am a neophyte and I ask to you experts a mana.
I explain a little the problem has still not been resolved:
the control unit iaw5am hw610 a gp800 gilera burned.
I'm purchasing another unit of the same scooter, but of course there will be' put Mimmo off,my doubt is the following:
if I do the procedure of changing again the key with my master key will it work?or if caricassi the old map of the old ecu ricaricherei the code?
Another test that I did and pick up a map of the old ecu, cut is 304kb and do the coding the total file using immo decide,my doubt is that by comparing the two maps with the ecm I'm not clear if this operation was executed at the right address,
so thank you in advance if you can give me more info and possible the first to find myself with another ecu out,I'm attaching the two files from 304kb
and I hope in your help thanking you in advance.

[todos]

Hello, no you need to do all this, just a scodifica part of the control unit when the mountains on the first power-on coding with your key.....

[tekyla]

Todos graz for having responded ,
So let's see if I understand,
should I pull out the map
Do the scodifica partial ,then
reload the file scodificato and try to turn the engine over .

That software recommended for iaw5amhw610?

[todos]

you need only read the eprom with a program for the scodifica you do the partial and then write on the ecu..