Hi I wanted to clarify a doubt on the shedini spring...on the bosch I saw that there are 2 tipes of schedule in the round 8-pin and 10...I saw that one of the 8 working safely what is the difference and with the 10? it also works to a 10?
Hi I wanted to clarify a doubt on the shedini spring...on the bosch I saw that there are 2 tipes of schedule in the round 8-pin and 10...I saw that one of the 8 working safely what is the difference and with the 10? it also works to a 10?
There are no fast cars... But only foot heavy!!!!:cool::cool:
from what I understand around it would seem that those two pins that in some schedule are missing (as in my) are not otherwise used
gi? that there are I doubt I watching the other schedule I noticed that not all the pins are connected to the jack, then ? needless to balance everything right?
view my great prowess in the welds, I would like to make it as less as possible, to avoid damages to the unnecessarily
should solder all pi? to a question of the balance of the e xxx
ok thanks then I armer? of patience and will see? to do the complete job
this weekend, with the help of my friend, I finally welded sti blessed pin
in the end I decided to solder the ones connected to the jack, and the 4 to the end?, cos? me ne ? advanced someone escort
if it can? be useful to place the procedure that I used
I bought a piece of cardboard and I fixed above the e xxx (image 1)
with a needle I then washing the board in correspondence with the holes of the e xxx
then I hooked the e xxx to a support (image 2)
then I stuck the pin in the e xxx from above, making sure that the tips you posizionassero in correspondence of the holes in the cardboard (image 3)
I have set the support at the right height so as to have the pin to the wire of the e xxx and I finally welded in this position
the result ? not bad (image 4), the only thing ? the pins are not all the same height, but being just a spring ? a problem because? adjust themselves
being careful to make the holes in the cardboard of the same depth? and in doing so the support is nice to drive also this problem should be solved
1.jpg
2.jpg
3.jpg
4.jpg
Last edited by msport (exil77grande); 11-06-2014 to 12:50
I I bought them already? welded a little more? but I'm sure the work
also I searched already? welded, but I could not find them
the important ? that they are aligned properly, otherwise you have to put the hand anyway