you can confirm the same, even if I suggest that in our field we would like to all.Originally Written by sno74
you can confirm the same, even if I suggest that in our field we would like to all.
to begin with the g4 goes well then when one wants to continue you know the things to buy are never-ending depending on the work you do....
From my experience I advise you to first of a upa, then another recommended by colleagues, for gq to ****s e2p I was a little disappointed not to act in 16-bit 93lc66 ciai and good work.
I work with gq4x and upa, and I am fine..the 29f200 or 400 do that with the gq4x with its adapter and never have problems
I think I've only said that the gq4x does not read the e2p in 16-bit I also use adt to read the 29f200 and 400 hello.
to work on a 75 with a 27c256 I saw that the tl866cs ago but which adapter should I get?
Sorry that I may have missed some of the post but the GQ-4X the 29f800 the ago with no problems ?
.. if it's so? it will be? my next purchase !
Without problems
Thanks , I took a chinese complete with adapter but not me, the reading seemed good but the writing was a mess, you know, even if he has a guide on how to proceed with the read/write memories ?
I do not happen to use it all day for? I ? served pi? a time, and expense ? fairly contained.
sorry guys,I finally got a wellon vp390 and sincerely, using it to 27c of the 75 I had not had problems.
A few days ago I had read a 29f400bb a sid 305,I am going to read, and no,I do not read the contact of the first pin of the flash.
I want to put the memory on the ecu believing that there has been no consequences, and instead, the ecu blocked.
fortunately rewrite the file in serial, and the car starts again.
yesterday, however, 29f400bc,same problem
the flash is 44-pin on two sides with adapter 44sopzif
I checked all the welds and they are ok both on the programmer and the adapter
Write permission
Quote