We learn together to make the best use winols.

[SandroMarciano]

sorry, but maybe you did not understand what is a damos...
Need to study a ecu: for example, I have to study a edc 17cp14, if I have the damos, the amount on winols, and I see all the map with his name and his conversion factors.
The ecu specific on which you want to work very hardly you can? apply it directly to the damos, and then the work that you do in these cases ? a comparison of the maps (at least fundamental ones) are always more? or less the same!

To use winols, however, are not essential to the damos, ? a program that does not require the use of drivers such as ecm, but I consider myself to be very quick in changing, why? the program independently pre-select the maps you alleged, then c'? also the possibility? add others by selecting the area suspected, and pressing the "k".

[antonio.o]

I believe that without damos at least for the less experienced winols there is of little use.

[SandroMarciano]

winols is used when you have a thorough knowledge of the maps, where they are arranged, how they are made, etc.. The damos I also have the ones that have all... I don't know where they are, but if you can find the source, give a whistle! (also I would pay a reasonable fee to have them)

[pitty]

so let's say that if you know your map is fully you can open it without Damons. it remains to x? the test that do? to the pi? soon I hope. eh eh.

[SandroMarciano]

so let's say that if you know your map is fully you can open it without Damons. it remains to x? the test that do? to the pi? soon I hope. eh eh.

yes, but not ? cos? as difficult as it seems... I started with the edc15c7, then the maps of other edc15 the recognized eye without having studied, why? you know what to expect, how to recognize them in the values and axes!

[antonio.o]

yes, but not ? cos? as difficult as it seems... I started with the edc15c7, then the maps of other edc15 the recognized eye without having studied, why? you know what to expect, how to recognize them in the values and axes!

Maybe you could make a small booklet in order to understand us well as the various curves/maps.
Hello.

[SandroMarciano]

Maybe you could make a small booklet in order to understand us well as the various curves/maps.
Hello.

I'm sorry, but I don't have enough time to do that?, however, you can get it from you, I started to make screenshots of the map in 2d with the values of the axes and those of the maps, the conversion factors and the units? measurement, then every time I was in front of a map sfosgliavo the pages that I had printed and I looked at what would look like... ? pi? complicated said than done!
Then if you need are here!

[gameiruz]

Hi all, enjoyed the pu? help on how to use WinOLS, I am beginner and I can do WinOLS to start reading the SW manual ? essential. After I Share these documents have been of great help to begin to understand what to look for. Also advise you to know in detail who want to change the engine, cos? understand where to change. After spending ? the tip of the fingers and lashes burn

greetings

[Gia]

Hello and congratulations for the spirit of sharing.

I would like to ask to those who use it, after you have loaded the damos, you come out a flood of maps of all sizes. The browse a to a or c'? any method to select useful ones

[SandroMarciano]

the scroll in 2d then click in the top left where you see it written, for example, "bosch:16x16"