eprom programmer,what to do

[Xtreme0303]

on a site I found the diagram for diy the xprog, no one has tried it?

[sno74]

I advise you to buy a clone...

[Xtreme0303]

mmm...a name to do a search? thank you

[sno74]

please contact admin via the on-line shop you can? help and if you have issues then tells you to use.....

[Xtreme0303]

ok thank you!!

[sportknight]

to work on 29f that the programmer need? I saw that both the upa that the xprog that I was very interested don't do them..

[klajdin]

to work on 29f that the programmer need? I saw that both the upa that the xprog that I was very interested don't do them..

Hello! I took the TL886SC ago, many chip including 29f only that the adapter SOP44 did not give it almost never with the programmer and to the limit take it apart, I should get the sti days, already? tried it on AM29F800BB 48pin and that's okay.

[chare]

between the upa and the x-prog to begin what would you recommend for me?

xprog is a good thing.

[virus1976]

I appended I too am hoping to give a useful contribution to the discussion by bringing a bit of the tests made both on the job and with friends on some of the programmers that are on the market

top3000/3100

On paper they seem to have good potential? (40.000 unit? supported), but in practice are of disasters.
The software ? partially in chinese (the lesser evil),several of the unit? listed are not supported, the manuals ? totally absent, the Test IC is not working.
In any case, I've had problems with the ZIF.


Genius g540
? was one of the first programmers usb that I had and can I say that ? very reliable, unfortunately, not ? pi? developed and has a park unit? very limited.

GQ-4X
the laboratory use and does what it says ? always well-supported and for what it costs it is worth to buy it

wellon vp190,vp280,vp380,vp480
you can easily find around are reliable and support between 14,000 and 32,000 out unit? but they are now models out of production, especially the first 2.

wellon vp290,vp390,vp590, vp596
have replaced some older models do not have excessive costs and to cover abbondantememte the normal requirements

Wellon gp-1(gp-10)
it is part of the high-end programmers, the gp-1(version for european markets) is to be found for affordable prices, has support of about 32,000 units.

Regarding the Wellon around there are several models with acronyms strange type vp498,vp908 etc are clearly of the buffaloes, they are often older models with the casing changed

Xeltek superpro 500P
I have the version with almond-shaped eyes, never a problem, even if there are some things (like the usb connector and power connector) welded to the good(that you can't? have everything).
Supports nearly 43,000 units? and a documentation of all respect, there is, for some time the version 600P pi? fast and with some unit? added but I don't think the cost justifies the purchase.

Conitec GALEP 5
The use in the laboratory for about 2 years and ? infallible coast of pi? of the other but ? the one that has by far the best support hw/sw.
also available are (always produced by conitec) a series of brackets and adapters for the reading of the majority of the eprom/flash etc.

[sno74]

to work on 29f that the programmer need? I saw that both the upa that the xprog that I was very interested don't do them..

I use a g4, I have never failed me there wants to adapter and a little patience are difficult to position on the adapter, you must check the pins are not bent......