Slight vibration after the map

[elio]

Hi to all. I expose my problem with some of your help. I did remap some time ago a Ford Focus tdci 90cv quite soft. For some time, or perhaps it was also the first no, but I never realized) in full acceleration and especially in the third and fourth phase of release throttle fast enough I feel like a small vibration. Nothing violent, but a vibration that nn I wish that I could create problems later on. Thank you very much.
Small note......the car pulls much better in 1-2-3 then well-known that in 4-5 fatigue a little bit to the increasing rpm and the maximum speed nn is changed to a comma; 180 after a good launch. It is physiological to the car or do you think you need to review something? Thanks

[frantik3]

according to me, and to see the map and the vibration could be due to the turbo

[msport (exil77grande)]

if places ori and mod we'll provide to see if it could depend on the map.

[guidotacco]

I think that it is the flywheel (dual mass)

[msport (exil77grande)]

I think that it is the flywheel (dual mass)

I also thought of what at first glance.

[motorsport]

I would opt to write the file first ori and try so, maybe you can tell right away where the problem is from the map or fly!!

[fabry]

Hello check the damper torque (the leg below the transmission), because often by the time you consume the support in the rubber and tends to vibrate the car during acceleration,but if you vibrate the engine even at idle then ? check the flywheel (dual mass). Hello

[Tom79]

Hello the engine to a minimum as it turns ?? it could be that there are too many advances and the engine runs a little bad ..

many greetings
Thomas

[legendaryslave]

you should try the car in order to understand something, but your description makes me immediately think of the flywheel

[coma]

If I'm not mistake? the bimassa are mounted just above the 100 hp right ?