In that sense it's not the law? You create a file in the wrong, empty or just not reading?Originally Written by munro
In that sense it's not the law? You create a file in the wrong, empty or just not reading?
not reading
Depends on the ecu. Here's an example: with magpro, if you select "all" to read and write a edc16c8, the sw plant. Instead, with the check on the "only", not only the flash is read completely, but in a manner that is complete, that is, how does the bdm.
Patience is the virtue of the strong, but what happens if they lose?
I do not agree, I read a 1.3 mjet with chip spansion correctly. the problem I had in writing.
possibly the file not read ? correct.
exact law, but writes the spansion then the read file was corrupted.
[IMG]http://bannerbreak*****/banners/3/563/135700419269659378.gif[/IMG]
zioweb you can post the file to the bed of the spansion I sambra a bit strange, might not have read anything at least I think correct me if I'm wrong
Tomorrow I'll post it. It was also consistent, with the maps and everything.
so if y momo 1.3 mjet 105 hp to have the original map should I do only read the data... why? I tried with read all and me ? released a file of 400 kb!!! But basically that diggerenza passes between a read everything and read only data?
you should ensure that the chip mounts..? a spansion will not read it with mpps but only in bdm or equipment official type kessv2...
to write it instead mpps writes it to work, cutting the file to 1mb...
guys,I write qu? why? ? always a the 1.3 multijet but ? an opel meriva
the control unit must be must a marelli or it may also be bosch?
in both cases, there are problems in reading and writing?
I have the mpps v5 so I don't know if compared to the v12 is missing the protocols
Write permission
Quote