Hi all, I have tried in the removal of a Fap in a Great point about using the ecu...fe and I noticed that the machine after a p? it goes into regeneration without any warning light on the dashboard, can inhibit signaling only on the dashboard?
Hi all, I have tried in the removal of a Fap in a Great point about using the ecu...fe and I noticed that the machine after a p? it goes into regeneration without any warning light on the dashboard, can inhibit signaling only on the dashboard?
Last edited by easyalbert; 04-11-2012 at 10:13
hello,ecusafe does not work on that vehicle then you have to go to someone who knows how to do it manually if you need, we are available.
[IMG]http://bannerbreak*****/banners/3/563/135700419269659378.gif[/IMG]
Ok, as I thought from the data in the diagnosis, does not work....at least now I have confirmation...as regards the management of the turbo on this car ? electronic pierburg, has anyone tried to translate the same system on a 75 with management fully mechanical pressure? According to me for linearity? you should be able to do without too many problems having an overboost right where we need it..
the light on the filter is clogged you check that, if c'? a blockage excessive, but if ? programmed do not necessarily have to tick the lamp
It is, in fact, I agree with what you just said...and also there ? also that a certain number of miles, especially on the 500 mjet which in theory should determine the degradation of the oil and the eventual replacement.....
Perhaps if the diagnosis perform the replacement filter leading to clogging to zero, and see what happens. However, I know some things need to be modified manually to remove the regenerations programmed.
to delete the fap I know that before you f? physically and then electronically, please contact a trainer expert
as all of the 1.3 mjt there are things that have to be made necessarily by hand in anyway ? a good rule to follow certain procedures before removing the electronics
GALLO ORI + KESS V2 ORI
the work remember that you are always the first electronically and then physically.
[IMG]http://bannerbreak*****/banners/3/563/135700419269659378.gif[/IMG]
Originally Written by explode82
the exact and the procedure to be done before writing this
Procedure:
1 Connect the diagnosis, and with the motor a >70 degrees make the replacement of the FAP to bring the ashes to zero
If between actions/activations not c'? the replacement of the FAP do a forced regeneration
2. Check the list of parameters that the ashes are set to zero
3 Write the modified file
Write permission
Quote