I bought the galletto v54....connected to 3-pin adapter but unfortunately when I click on data the ecu does not read anything.....does anyone know what you can depend on.?
Thanks
I bought the galletto v54....connected to 3-pin adapter but unfortunately when I click on data the ecu does not read anything.....does anyone know what you can depend on.?
Thanks
Update: after several tests I managed to read and save the data from the two control units...hw is the same but the sw is different...***** and you advise me to proceed now in order to insert the amendments of the one in the other? Grazienda thousand
Open the flash file of the edited one and paste all the maps in that ori.Originally Written by sandros
If so, you don't like, you only have another road.. and it's torturous.. to update all ecu's to the same version sw and make them push directly from one to the other..
Live ****** & you Die a HERO !
Hi trank, thanks x the answer. ...with which program I advice d copy the maps? I am newbie and I don't know how to proceed
I could say a great nonsense... but probably if you have the hardware the same and different software it could also be that it would be the same as the ecu because the older edc15 reads in total from the outlet, the flash, and then putting the file that is mapped, you'd have a complete re..
Or is first to send the file that you want to enhance someone competent and if it does remap.
With ECM...
On edc15 with different sw hangs the key to the immo.. the Only solution is the copy and paste by hand.
In the Boot I have made dozens of exchange SW..
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
Hello cinqueturbo "boot!" na word and as you do in boot is the controller-the edc1
5c5 )thanks
However tramky I used the ecm to do a copy paste of the maps, now I'll explain what I did so you can tell me if I have done everything in the right way:
Open flash the ecu modified in a window of the ecm and in the other the fllash of the original, on the right of the one you modified they were, injection, injection partial and three other entries, and I deduced that they were changed maps, then I opened a map once and I did save the map data for all of the 5 or 6 maps now I can't remember, then from the ecm, in which was opened the original flash I clicked on the maps to the right and I did open the map data, and then update, this for all the 5 or 6 maps using the map data stored by the ecu mod, I eventually made the save and exported as a file that is modified.
now the checksum is different, and when I open this file but it's not me, it recognizes it automatically with the driver first.
I've done in the proper way? still missing the other before trying to send it to the ecu?
Thanks
Write permission
Quote
