double curve "torque starting" juliet

[MultiBravo]

dear friends,

I was studying the curve of "the couple in starting" a giulietta 1.6..
I don't understand which of the two change since? there are two attached; usually on the edc16c39 ? only the curve.

I enclose a photo.

[ugoboss]

and if you make them all and two.........

[mobilservice]

What is this curve? or better..... the trend of the curve in the object of what it refers to?
Now You the' you have understood that you should forgive my ignorance? I am new and I am so hungry to learn

[MultiBravo]

I thought I was doing them I both..

the map determines the amount? of diesel fuel in the starter according to engine temperature, and engine rpm..
we take every single "crest ": the high part of the curve ? refers to a temperature close to -30 degrees while the pi? swipe to the right pi? the temperature goes up. each "crest" refers to a certain number of laps..usually go to Step 50
speed of up to 1400..

[SandroMarciano]

the first that you find ? the one that used to start the engine with the s&s

[ugoboss]

the first that you find ? the one that used to start the engine with the s&s

are you sure you Sandro, because I checked a couple and the two curves are absolutely identical, to that point, why make two?

[SandroMarciano]

are you sure you Sandro, because I checked a couple and the two curves are absolutely identical, to that point, why make two?

Damos don't mind (the pi? of the vaults)
However, will be the same why? he may not have had the need to differentiate them at the time that the car ? was made by Fiat... I'm kidding, but it seems to me the reason for the pi? plausible

[MultiBravo]

? verooo..

and are the same I think..

[MultiBravo]

I give it a pinch more? torque at start-up s&s..
however, even the "big" germans have the wrong maps starts to warm a little time ago..
there have been complaints about the first 2.0 jtdm that had goodwill long with s&s; if you look at the curves, has ir? torque at start-up, the 1.6 than the 2.0..
maybe ? them the reason and, if we raise a little bit the torque of the first curve, maybe the starter is fixed.