Problem after writing via OBD Opel Vivaro 2.5 Dci EDC16C36

[chiptuning.cro]

After you have written the mod file via OBD on the Opel Vivaro, Renault engine 2.5 dci with the EDC16C36 the machine does not work well.
But don't take turns and sighiozza and diagnosis fault DF053 "Rail pressure regulation function"

I tried to rewrite the file ori but the problem remains.

Reading and writing, both with the mod files and after with the ori and always went well without any problems, and the inietori are encoded.

Someone already happened?
What it could be?
And it is just a coincidence or something else?

Thanks in advance!

[blackwolf76]

according to me it's not the writing. From the error it seems to be a problem in the regulator pump HP.

[alex68]

written once, but I agree I would do + these ecu must be made in bdm and you equal your ass.

[rego88]

right.... if with the original file, the problem remains ? a problem in the regulator of the high pressure pump if you dared a little too much with the request of the rail on the map???

[rego88]

written once, but I agree I would do + these ecu must be made in bdm and you equal your ass.

I have written about 1.9 always with is the ecu kess 2.07 serial, only drawback ? that when it ends the writing you turn the wrench with a written request maintenance, as if you have to do the service, reset the service coupon and all ok

[chiptuning.cro]

if you dared a little too much with the request of the rail on the map???

No, I only wanted to disable from the map below the speed limit that is set to 140km/h, in the e2p

[ugoboss]

sorry but how did you work the limiter in the e2prom via obd?

[chiptuning.cro]

sorry but how did you work the limiter in the e2prom via obd?

Using the map clearing a bit and mettendollo to zero, you can disable the limiter, which is written in e2p.
You can't' change the map (the value), that I know of, but you can only do off-on.
The' I've done on a Trafic with EDC16C33 with success...

[ugoboss]

you can see an example of the change of the bit?

[rodcraft86]

perhaps he has lost the encoding injectors, have you tried to verify?