Domandona... scodifica 5AF

[darioz90]

Good evening, of course, ask a new question for? in this round I can't get out of it...
Scodificare IAW 5AF of a point , open the ecu and found the ground pin, but I don't know if I put in the correct way to do pin-out with the gallov54...
with the special tool I can not start even reading (clone\decode).

[darioz90]

I'm sorry , I was wrong in the title are cooked , I wanted to write 59F

[obd75]

you d? some error? the type system is not boot?

[darioz90]

by an error, and me doing the log , but does not tell me anything else... I do not want to mistake the connection pinout for the 59f... you ... an image here on the forum?

[ecusolution]

hello to my esperinsa staff the cock 54 is not able to do these ecu I riuscio to read but could not write

[darioz90]

I dunno , riprover? I do not want to mistake I, with the connection pin-out, but I followed one of your pdf!!
no one ? cos? kind to post a picture with the pin-out of 59F ?

[obd75]

I v50 and the pdf are correct, I will say that with the v50, I've ruined 3-4 59f in writing.
instead with the old cable 1250 read from and written to without problems, we are talking, of course, hw above 100 boot mode

[darioz90]

perfect... and then you say that ? the v54 which is not to be....
domandona I have a mpps12 and a kessV2 ... scodificare the 59f can help me?

[obd75]

don't you s? to say the v54 but my v50 f? of these jokes.
with regard to other programmers,possibly if your 5af ? with hw in excess of 100 something you can do(I think but am not sure)read the file of the processes with the sw for scodifica.

[darioz90]

perfect , so I have to mount it somewhere and do it all over serial...