I took a Kess V2 clone and as expected ? accompanied by a copious amount? cables, wires and interfaces. Is there a reference guide on how to use them? ..why? I wouldn't know where to put your hands!
Thanks!
I took a Kess V2 clone and as expected ? accompanied by a copious amount? cables, wires and interfaces. Is there a reference guide on how to use them? ..why? I wouldn't know where to put your hands!
Thanks!
Meanwhile, he began to get help on the official website alientech and you will see every single component to what you need! however, from the photos you have everything you need...
The jlink ? the tool for resetting of the scriptures of the kess
Then you have the tool to read in boot to connect to the kess
12 volt power supply
The cable to read in k-line or line can
Install the program and do as I said...if you want to get the help you need to have your pc clean of that? without kess installed and then install the software from the site alien you download the help you save them to uninstall the software and install what you have bought and copy all the help in the C
Installed the sw original, has created a folder 'Help' with 4 rows, then I downloaded another folder 'Help' 280 Mb with several files that contain the various instructions. Question, these help files are displayed when I select a car? (Now I don't have the equipment on hand and I can not try).
For the links, tell me if you are on the right track:
The Kess ? the box on the pi? great that I connect from one side to the pc, and the other to one of these 3 cables: one ? the cable to the OBD output to the line-k (for use with wire to the blue); the other 2 wires are the ones at the bottom, but in which cases are to be used (especially the one in the bottom right with the switch)?
The jlink (this I recognized c'? written above), I connect it to a pc side and on the other band, grey and ..comb, connect (solder?) the print of the kess?
The tool to read in the boot to connect to the kess ? the box on the pi? (bottom left) which is connected to the power supply and the cable to the terminals (top left)? With this module I boot tricore?
When you download the help file you will find all the information you want even why? you have made me 15 questions
When you load the help file of the times you will find pictures and other times no, I happen to find them, but it was the kess follows you step by step and ? a pleasure to use
the tool in the boot ? what is to be connected to kess ( which must be connected to the jack 12 bravo)
for the jlink I have put the image
only 15..? but I still have many more!
Thanks 1000 for the info
A question vital...the module to read in the boot which voltage should be supplied? In the kit there? a power supply but only the cable.
Since we're here, a question I.....
the blue wire that is on the cable to the OBD when v? used, and how and why?????
Thanks!!!!!
That is to be inserted on the connector that comes from the obdii cable and should be connected directly to the edge of the K-line that comes from the ecu, only in some cases where you are unable to read through the OBD.Originally Written by MarcoDJ
Thanks!!!!
hi in case you need to reprogram the kessv2, the balance of the band, we attack the j-link... and then? as I open two icons of the sw j-link?
resp thanks
Quote
