help edc16u1 golf 5

[andrew64]

hi to all I try to help I recently purchased bdm 100 on the baya and I wanted to make reading a bosch edc16u1, but I realized after, have flat instead of having caused something serious to the control unit.
in fact, before I could read it and write to tour with mpps v5 now is not giving any sign of life
? can resume it ?or as I think I burned up the micro

[admin]

hi to all I try to help I recently purchased bdm 100 on the baya and I wanted to make reading a bosch edc16u1, but I realized after, have flat instead of having caused something serious to the control unit.
in fact, before I could read it and write to tour with mpps v5 now is not giving any sign of life
? can resume it ?or as I think I burned up the micro

If you put the e xxx in the correct position and does not go 100% to the burned unit

[andrew64]

sr exchange the micro to the recovery, according to you,

[alfajtd]

you can only take a...

when you power where you don't have ? almost impossible to put it back applied...

[sportknight]

I when I installed the bdm I tried to read a control unit,seeing that no-one would read it, I tried to invert the e xxx,the bdm was not the mpc, and then I was do nothing

after a few days you probably ? cooled, having regard to all the evidence that I had done that day

the fact is that I tried again and ? the game on the first shot with the bdm

probably the bdm was not installed correctly the first time

try to cool it off even if you use the c'? the problem is that the power takes it from e xxx...

sorry, but why? you have not read directly with the mpps that these are easily?

a strange curiosity? my,if I connect a bosch bdm but use supply through the comb of the control unit instead of the original transformer works the same?

[andrew64]

of course, with the mpps read and write, but I was trying the bdm 100che me esra arrived and to my lightness I have not checked the flat and as I suppose goodbye ecu?

[sportknight]

you had powered from the power supply of the bdm?

[andrew64]

I powered the ecu from the power supply of the bdm

[sno74]

take the ecu w put it on the machine if when you shoot the picture, there are the fans to throttle me know that ? dead the micro damned cable to the contrary before connecting the ecu, always check on the e xxx on that pin out voltage you don't have the wiring diagram for edc 16

[andrew64]

of course I have the diagram but my fault I have not checked and made an omelette with micro