the fiat brava jtd 105 year 99

[sandros]

hello excuse my ignorance on the subject ,I'm new and I would like very much to learn , I have two fiat brava jtd 105 both the year 99 and was already remapped by remapper professional a ca.5 years ago, the other, instead, and still the original ,now I would like to read the one already modified and put it in the original , and as yet I have no program and no experience in the matter ,I would like to consigliaste that progr do I have to buy and how to use it
thank you in advance

Sandros

[Macchinista]

Hello. Unless the 2 units are not perfectly equal as numbers sw and hw you can not read the file that changed and write it on the original one. However, your ECU should be EDC15 then with the galletto or mpps do safely.

[sandros]

hello Macchi sorry but I do not understand , I can't read the edited one and write it in what is still original? or as
thanks

[Macchinista]

Exactly. If the two units do not have them same numbers on the Hardware and Software (hw -sw) you can not withdraw the file from a and write it on the other, the risk that the car will not go more in motion.

[sandros]

sorry, but there is the possibility to do this operation? maybe I should save the code key and then re-write it in a that already changed!

[Macchinista]

You should first see the numbers that you said about the ecu. Maybe you are luck that are the same and then you can write the file to Flash the other ecu. If instead this were not the case, you can redo the changes by hand by copying from the file that have been modified using sw to modify maps as the Titanium.

[sandros]

ok, so I have to buy Ecm Titanium ,but I can also read with this prog ? and if you are, I can read it through socket to 3 pin ? why not the OBD
thanks.

My nephew takes the Delphi Gold prog bought it new a month ago ,we tried to read the Ecu but always unable to connect , we have made many attempts but nothing to do.

[Macchinista]

Ecm titanium, and only an editor program of the file after the reading. So you'll need a tool to read and write type the galletto v54. The Delphi if I'm not mistaken is only a diagnosis that does not allow you to perform the job that you want to do. Things are complicated further since your car has no obd. Because in the pin out on the bench I don't think I can't read this unless dissaldi the eeprom.

[sandros]

hello Macchi then as you say there is no possibility of read and write directly from the outlet three-pin
in the engine compartment,

[sandros]

so I guess it will be hard for me is the edit