matiz 800 2002 egr

[antonio031272]

Hi I wanted to ask for your advice I have read with the gf galletto clone the file that lay below I exclude control egr given to me by p01404
if you can do it after the lamp will be turned off?
thanks in advance for your help

[msport (exil77grande)]

you have not posted any file, and the section has nothing to do with move the discussion,I ask you a little bit more attention in these small things, and trust me, instead of wasting time on this garbage type move discussions we could do things the most important type complete post lots of files ori in the database that I still have to enter.

[antonio031272]

you have not posted any file, and the section has nothing to do with move the discussion,I ask you a little bit more attention in these small things, and trust me, instead of wasting time on this garbage type move discussions we could do things the most important type complete post lots of files ori in the database that I still have to enter.

I'm sorry it's just that they're on the job and did it in flight
I put the file, and again my apologies

[Gerard]

on this car just to clean it so that you go to work and then close it so not encrusted and does not block ir?, the light comes on why? the valve ? locked
Closing the light does not turn on why? the engine management controls the actuator and not the air mass, so if the actuator works the light does not turn on, I hope I was clear

[antonio031272]

Crystal clear and helpful, thanks