scodifica twingo 1200cc

[Alessio93]

hi to all guys I would have a problem with the scodifica of this machine .. the control unit that mounts and a safir 2 I shot on the forum and I saw that c'? a procedure that acts on the 27c512 eeprom putting in conrto of the legs . someone of you has an outline exact ? the pins of the eprom 21-22-23-24 must be jumpered to ground ? from the outset, for the moment, without decote mts !!! thanks to all

[jolidj]

then. you have to put in short the pins parallel, which is the part where you have the pin x limmo.
example 28 5 27 6 and so on , put in a short pair x pair of tweezers , you hear the relay that off.
usually just the first 3 couples. let us know , I do so and it works.

[Alessio93]

You have a pattern ?? Thanks

[Alessio93]

All fixed !!! It was enough to connect intermittently feet 20e21 thanks !!!

[gabrilupo]

from what I know you must also cut the pin 30 of the control unit, so that the car does not resume the code

[ema74]

it depends on which eprom mounts 27c512 or 28f512

[gabrilupo]

I have always acted in a bridge intermittently the pin 20 and 22 in some cases 21 with a wire with a light bulb (5 w after you cut the pin 30 on the 55 pin feel enable mode? random all of the relays butterfly actuators etc etc (obviously with the ignition turned on) after a few seconds ? made only problem the light on the dashboard stays on.

[scinti]

I know, having made a few days ago pin 37 safir 2 55 pin

[ema74]

I do them with the tms374