problem mito 1.3 multijet

[francescosparco]

hi all.. I have a problem.,. use the rooster clone v50. I tried to read a alfa mito 1.3 mj, ecu data ok.. go on writing, and after a moment I get error contact the supplier.. what is? nn you read normally with the cock?

[Exelion1986]

hello sorry but you say you tried to read it but then you said you go on writing... the error you by the read or write?
anyway, with this obd ecu is read only in a virtual, try to go see it in the installation folder of the software, there should be a document with the list of all the cars
in particular, that the model of the ecu mounts on your side?

[francescosparco]

in fact, I was wrong to write.. I wanted to say I try to read it, and nn... I have read that it is in the virtual..but how to do it?

[Exelion1986]

do everything you normally, it's just that the file of the fishing from the database instead of reading it really
it could be that you get error why? not ? this file
check the driver list in the installation folder of the rooster and see if ? listed your car

[francescosparco]

here, then where? the problem..thanks

[Exelion1986]

no ? my guess... I'm not sure
however, you can always make it to the bench ? also pi? safe
the mountains are a 6f3 or a 8df?

[francescosparco]

I had read on a forum a similar thing . Anyway, if I do bench I don't know even from the dv start

[Exelion1986]

not ? a difficult thing, just a p? of manualit? and patience
in the software of the rooster, however, there are some excellent guides, and if you need a hand to ask
first of all, the procedure ? different depending on the version of the controller, the mountains, 6f3 or 8df

[Macchinista]

The gauls clone that make the virtual read are rare!! For? if good design work...

[gianni1001]

The gauls clone that make the virtual read are rare!! For? if good design work...

sorry I'm intruding x,' I am also the owner of V54 clone
could you explain better how is the virtual read?
thanks a lot