hi guys does anyone remember how it is measured and that value should you give them? thanks dell for help
hi guys does anyone remember how it is measured and that value should you give them? thanks dell for help
With The Diagnosis?
simple..
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
what should I watch for ?
Pressure Turbocharger..Originally Written by macinische90
or Absolute Pressure
or Suction Pressure
depends on diagnosis diagnosis..
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
pressure turbocharger there, and c, and pressure goal measured, but I don't know the values that I should give
I forgot..
with the engine off 990-1024 mb
with the engine idling +- the same
under fire depends on the loaded map usually ori the 150hp is 2200-2400 mb less than 1024 atmospheric 1,2-1,4Bar
always s? remember...
"The only thing that stands between you and your goal are the********* continue to tell you why you can not reach it."
then it is processed together with the mass air flow sensor and used for the stoichiometric ratio,thanks now I know where to look
sorry but how do you, instead, to see if ? perfectly calibrated? I don't think that this sensor is the lord, or am I wrong?!?!?!?!?
A first test can? be to remove the sensor from the air intake and leave it in the air, in diagnosis to compare the parameters turbo pressure measured with atmospheric pressure, must be nearly identical.
Otherwise with a pressure pump with a pressure gauge connected to the sensor you can put a 2 bar pressure read on the pressure gauge and diagnosis in turbo pressure measured you have to have the 2 bar
this I never would have thought of that ... thank you
I thought that was to do a procedure type to check for proper operation of the mass air flow sensor with a tester on the ground, and the output 1V....
Anyway, tomorrow testero.
Write permission
Quote