hi I wanted to verification by the expert user if the file read via obd with galletto 2 of a c4 1.6 hdi 110cv is correct because it is open I find at the beginning of the file all ff and then find at the end I think of the maps with titaniunm 1.61 open it as c4 981_516 are quite a bit doubtful that I made a good read
The file is in place!
Gallo via OBD lege only partial, where are the tables...
In BDM, the file would be different...
I had thought that it was a reading of the sun tables, but I wanted to confirm which you have given me thank you
given that you have the gallo2 if you can open the unit and made a complete reading, you never know.
ugo ---- president A.E.P.
an eye to this car ,
I'd recommend you to do it.
with a full backup, you're always calm and restore easily
someone has bakcup bdm complete this unit?
does not work cos?, the open BDM is, especially on these ecu's, also to be saved in the e2prom, given that when you do wrong the writing of the damage is in the e2prom and this ? unique to each car.
Consoglio you read in the BDM his file, to avoid having problems.
with the cock, the read quietly in the bdm... ? the only way
pnaus
I would not say something wrong, but the fgtech reads from the serial the same file that would read in bdm I have written more? times these ECU if you do it by serial respects the letter of the procedure under penalty of loss variants, another problem of these engines with a map done well tends to slip the clutch
Write permission
Quote