URGENT reading BDM (possibly complete) for a doblo 1.3 85cv MJD6F3HW03R

[emilground]

The data obtained through the ID in the serial are:

51826698
MJD6F3HW03R
3455D180
6F3.D1h
99 F9 0131
.6F3.D1

I don't know what happened, but reading in the serial at the end of the reading has given me a file that is 0 kb, and l? the car does not ? game pi?. Reading BDM file ? corrupted.
If someone has a complete reading would be better.

The vehicle ? firm and should I put it back in the bike as soon as possible

Thanks !

[alfajtd]

http://www.professionalchiptuning.ne...4&d=1359893153

See if you solve this....

remember scodificare partially e2p....

[emilground]

ok try this, thanks !!

[alfajtd]

Let me know...

[emilground]

Thanks a lot, everything is ok, the vehicle ? party!!!
Sorry if I did know before, but only now I retired.
Thanks again, good make !

[alfajtd]

Very good.... The number of sw ? upper (update)... But as you see, and going well...

It only verifies that everything is ok... To the max do a proxy alignment,
Reset the parameters oil, dpf... The km will be different in the ECU... as well As codes for the injectors...

[emilground]

It is, in fact, the km is a lot less and codes injectors tomorrow write them.
The absurd thing ? you have lost all of the data simply by reading the car !
absurd, I can't explain how it is possible ! and the best part ? I ? happened (in the same day, BLACK is BLACK, also on the alfa mito, for which I made a special post for the file.
Anyway Thanks again !

[alfajtd]

azzzz......change tool....

[emilground]

but ? the first time this happened, I have used it with a the galletto2 V50 and with the other the V53 and then made a lot of bosch and siemens, and I never had a problem.
for? the strange thing ? the dobl? in serial would have had to read it, giving a single file, 2.5 mb (MPC and flash) in about 100 minutes, instead of reading ? failed, while the myth did not even read the virtual giving error and from here I open to use the bdm. Boooh never had such a thing